For complete bathrooms, shower room, or combinations of bath, shower, bidet wash-basin and W.C.

To connect shower, bidet, bath and wash-basin, use the two 40 mm inlets in the base of either side of the Saniplus. The waste must have a 1 in 40 gravity fall into the Saniplus inlets. We recommend that low and high trapped items (eg shower and washbasin) be separated and taken into the unit on opposite sides. Allow about 11 cm from side of unit for inlet pipe connection.

Saniplus will pump up to 5 metres directly vertically, or a maximum of 100 metres horizontally with a 1/200 gravity fall (minimum) constantly throughout the run to the point of discharge. Any vertical lifts should precede horizontal runs, and should be installed directly vertical from the unit.

If you wish to pump vertically and then horizontally, you may calculate that 1 metre lift is equivalent to 10 metres ‘horizontal’.

Therefore you can pump 3 metres vertically followed by 10 metres "horizontally", or 2 metres vertically followed by 20 metres ‘horizontally’ and so on.

Each bend can be considered to be equivalent to 1 metre of a ‘horizontal’ run, so reduce maximum horizontal pumping distance by 1 metre of run for every bend.

Where a piperun is over 40 feet in length, we recommend the bore be increased to 32 mm (1.25") from that point onwards.